Home > Equipment > The Radios > Kenwood TS-700G
| GENERAL | |
| Type: | Amateur VHF transceiver |
| Frequency range: | TX: 144-146 MHz RX: 144-146 MHz |
| Tuning steps: | Analog / continuous |
| Frequency stability: | Within 200 Hz during any 30 minute period after 1 hr warmup |
| Mode: | AM / FM / SSB / CW |
| Channels / memory management: | 11 optional XTAL controlled |
| Repeater shift / offset: | ±600 KHz |
| Power supply: | Mains: 120 / 220 VAC (120 / 240 VAC for England) or 12-16 VDC (4-pin Jones connector) |
| Current drain / power consumption: | RX: 800 mA (No signal) TX: Max 4 A @ 13.8 VDC |
| Antenna impedance / connector: | 50 ohm / SO-239 |
| Dimensions (W*H*D): | 278*124*320 mm (10.94*4.88*12.6″) |
| Weight: | 11 Kg (24.25 lb) |
| Other features: | 1750 Hz repeater tone. |
| RECEIVER SECTION | |
| Receiver system: | Single conversion superheterodyne (AM/SSB/CW) IF: 10.7 MHz Double conversion superheterodyne(FM) 1st IF: 10.7 MHz 2nd IF: 455 KHz |
| Sensitivity: | AM: 1 uV (10 dB S/N) FM: 0.4 uV (20 dB noise quieting) SSB/CW: 0.25 uV (10 dB S/N) |
| Selectivity: | AM/SSB/CW 2.4 KHz (-6 dB) 4.8 KHz (-60 dB) FM 12 KHz (-6 dB) 24 KHz (-60 dB) |
| Image rejection: | 60 dB |
| AF output power / speaker: | 2 W at 10% distortion / 8 ohm |
| External speaker connector: | 3.5 mm, 8 ohm |
| TRANSMITTER SECTION | |
| RF output power: | AM:3 WFM:10 WSSB (PEP):10 WCW:10 W |
| Modulation system: | AM: Low power FM: Variable reactance frequency shift SSB: Balanced |
| Max FM deviation (Factory set): | ±5 KHz |
| Spurious emissions: | Better than -60 dB |
| Microphone impedance / connector: | 500 ohm / 4-pin (Metal locking ring connector) |